Differences

This shows you the differences between two versions of the page.

--- dcprotocol:hub_client:ipv6:ipv4 [13/01/2013 15:53] – ppk
+++ dcprotocol:hub_client:ipv6:ipv4 [13/01/2013 15:53] (current) – ppk
@@ Line 3: / Line 3: @@
 Client sending in $Supports IPv4 and hub will check his IPv4 connection availability.\\
 Hub must get client IPv4 address to be able to check if client is sending correct IPv4 address in commands, without checking will be DDOS possible as in old dark dc times when hubs don't check IP in ConnectToMe.\\
-When check for IPv4 success then hub will enable IPv4 bit in client [[dcprotocol:hub_client:myinfo|MyINFO]] (see [[dcprotocol:hub_client:ipv6:ip64|IP64]] extension for details) and client is allowed to use active mode as normal IPv4 client.
+When check for IPv4 success then hub will enable IPv4 bit in client [[dcprotocol:hub_client:myinfo|$MyINFO]] (see [[dcprotocol:hub_client:ipv6:ip64|IP64]] extension for details) and client is allowed to use active mode as normal IPv4 client.
 __Example how it works in CzDC and PtokaX:__\\